CIS-Certified IPC Specialist

J-Standard Soldering Process

This is a comprehensive, hands-on solder training program based on J-STD-001. The program describes materials, methods and verification criteria for producing high quality soldered interconnections. The standard emphasizes process control and sets industry consensus requirements for a broad range of electronic products. The operator proficiency program consists of five modules detailed below. Candidates must successfully complete module one and then can take any other module/modules consistent with their job requirements. All written exam grades for Modules completed will be averaged together. The minimum score for successful completion is 70%. The minimum score for each lab session is also 70%. Upon successful completion of the course students will receive an IPC J-STD-001 Certified IPC Specialist certification good for two years.

Module 1

General Requirements

This module is an introduction and overview to the entire contents of J-STD-001 Rev G and is a prerequisite to any of the following four technical specific modules. Module 1 consists of lecture, review, and an open and closed book written exam. 

Module 2

Wires and Terminals

This module provides requirements for wire and terminal applications consisting of lecture, review, and instructor demonstrations. The students will prepare and solder wires to turret, bifurcated, J-hook, pierced, and cup terminals. Students must demonstrate proficiency in preparing and soldering wires to the above terminal types and pass the open book exam.

Module 3

Pin-Through-Hole Technology

This module provides requirements for though-hole technology consisting of lecture, review, and instructor demonstrations. Students must prepare and solder through hole components to a printed circuit board. Components include a variety of axial and radial leaded devices. Students must also remove components from a PCB in a non-destructive manner. Students must demonstrate proficiency in the above and also pass the end open book exam.

Module 4

Surface Mount Technology (SMT)

This module provides requirements for surface mount technology consisting of lecture, review, and instructor demonstrations. Components types include 1206 through 0402 chips, SOIC’s, PLCC’s, SOT’s, QFP’s, TSOP’s, etc. The students must demonstrate proficiency in various types of installations (convective and conductive) and removals and pass an open book examination. 

Module 5

Inspection Methodology

This module provides requirements for inspection methodology and a basic introduction to process control issues. Through lecture and actual inspections of a sample PCB the student will demonstrate their proficiency in identifying acceptable and defective conditions according to the Standard. An open book examination is also required. 

 

IPC JSTD CIS - Reisterstown MD

Monday December 16, 2019 through Thursday December 19, 2019

IPC JSTD CIS - Smithfield, NC

Monday February 10, 2020 through Thursday February 13, 2020

IPC JSTD CIS - Fredericksburg VA

Monday February 17, 2020 through Thursday February 20, 2020

IPC JSTD CIS - Reisterstown MD

Monday February 17, 2020 through Thursday February 20, 2020

IPC JSTD CIS - Cumberland PA

Monday March 9, 2020 through Thursday March 12, 2020

IPC JSTD CIS - Alajuela, Costa Rica

Monday March 16, 2020 through Thursday March 19, 2020

IPC JSTD CIS - Rock Hill SC

Monday March 16, 2020 through Thursday March 19, 2020

IPC JSTD CIS - Smithfield, NC

Monday April 13, 2020 through Thursday April 16, 2020